http://www.milinst.com
Hextor by David L Buckley - September 2001
| Index | Index < > |
Knee-bracket
| The Knees are strengthened by a bracket to which the two leg servos are fixed. Assemble the six brackets with glue and affix the servos by using double sided foam tape and wire ties - not really recomended - or hot-melt-glue. Note that the Hextor shown in the title page is a prototype without the knee- brackets. | 
|
Remove any bubles of glue which would prevent the top or bottom servos seating correctly.
| 2 | 
| 
|
| 3 |
| 
|
Affix the lower servos, the assemblies should be right and left handed so be sure to make three pairs.
| 4 |
| 
|
| 5 |
| 
|
| 6 |
| 
|
Affix the top servos, again, the assemblies should be right and left handed so be sure to make three pairs.
Secure with wire ties if you prefer.
| 7 |
| 
|
| 8 |
| 
|
| Index | Index < Top > |