tel. +44 1977 683665
http://www.milinst.com
Alex by David L Buckley - September 1998
| Back to Section Index | Previous | Next |
Eye LEDs
To assemble the parts you will need the Neck-pivot wire (part-17), the Mouth-push-rod (part-19), and three lengths of sleeving.
Feed the wires through from the front of the eyeballs, the two wires should be one above the other to leave room for the Eye-pivot wire to go through the eyeball.
Push the LEDs into the eyeball until just the rounded end is showing.
60 
61 
62 
| Top | Top | |
| Back to Section Index | Previous | Next |